Electronics problem during radio installation

We are trying to install a stereo in our 2005 Logan. We were happy to find that the wiring was already in place, even though the car did not come with any sound components. However, we ran into two problems:

1) The audio unit does not turn on. We've checked all the connections with a multi-meter, and the power definitely is coming through to the unit. The stereo is brand new. Anything we may be missing from aspect of wiring in the car?

2) After our attempt to install the radio, we now find that every time we turn on the car, the clock resets to 0:00. If we leave the car on, the clock will add minutes, but it resets whenever the ignition is switched off. This seems to indicate to me that we did something during the radio installation that has affected other aspects of the electric system.

Any ideas?
Thanks!

You need to turn two wires one is yellow I forget the other one is live ALL the time for the clock the other is from the radio on off have a check without ign on the one that is live with the IGN off must be swapped with the one that live with the IGN on
Stu

Thanks for your reply. Is there a wiring diagram that would show the wires you are talking about? The information you gave is too vague to start messing around with - so far, we have left all the wires in the original configuration.

I am working on it for you but I can tell you this its dead easy so watch this space for the answer

https://2img.net/h/oi36.tinypic.com/33e3nv4.jpg

Plan for the electricks are here BUT it does not tell you which to swap BUT if you are used to electrics then you can read this and figure it out
Stu

Here is the answer for you I have just recieved from the German Dacia Forum

I Know you can read this


Hallo Stu!

Dauerplus ist ROT und der geschaltte ist GELB
Ich denke, das meinst Du, oder?
_________________
Gruß,
Michael

So just swap one side around ie from the stecker pull out red and put in the place from yellow and put yellow into reds place
BUT ONLY ON ONE SIDE